Page 153 - Catalog 26 2019

POWDER ACTUATED

THREADED STUDS

Threaded studs are available in 1/4"-20 and 3/8"-16 thread diameters with a variety of thread and shank
lengths for use in concrete, some types of concrete block, and A36 or A572 structural steel. They are used
for applica ons where it may be desirable to remove the fi xture, where shimming may be required or for
suspending sprinkler systems.

THREAD SHANK
PART NO THREAD PIN DIA
LENGTH LENGTH
ANDS-0705 1/4-20 3/4” 1/2” .145
ANDS-0707 1/4-20 3/4” 3/4” .145
ANDS-0510 1/4-20 1/2” 1” .145
ANDS-0710 1/4-20 3/4” 1” .145
ANDS-0712 1/4-20 3/4” 1-1/4” .145

THREAD SHANK
PART NO THREAD PIN DIA
LENGTH LENGTH
ANDS-3807 3/8-16 1-1/4” 3/4” .205
ANDS-3810 3/8-16 1-1/4” 1” .205
ANDS-3812 3/8-16 1-1/4” 1-1/4” .205

BX AND CONDUIT CLIPS

For the electrical trade, BX and conduit clips are provided in various sizes for a aching conduit to base
aterials where easy removal is not a requirement.
CONDUIT SHANK
PART NO PIN DIA
SIZE LENGTH
ANDC-38BX BX 1” .145
ANDC-0510 1/2” EMT 1” .145
ANDC-0710 3/4” EMT 1” .145
ANDC-1010 1” EMT 1” .145

POWDERLESS PINS

Hammer Drive pins are designed for permanently fastening a fi xture to concrete and some types of masonry. This fastener is designed
for use in a standard hand tool and should not be used in a powder actuated tool. The pins are formed with a 1/4" diameter head on
one end and a 0.140" diameter shank in various lengths. A 3/8" diameter steel washer is mounted over the point to retain the drive
pin in the fastener guide of the tool providing guidance during the driving opera on. The fastener is recommended for light duty sta c
load applica ons where holding power is not a cri cal factor. It should not be used overhead.

PART NO LENGTH DRIVER TOOL

ANDH-1407 3/4” 2lb Hammer Recommened for
ANDH-1410 1” best results.
ANDH-1412 1-1/4” PART NO
ANDH-1415 1-1/2”
ANDH-1420 2” TLDH-1400

Posi-tech 800-548-6728 Fax: 800-457-5156 email: sales@posi-tech.com Page 153
Copyright Positive Technologies, Inc 2018